Before you start
- Set your computer's output to 5.1 or 7.1: Windows → Sound settings → your output → Speaker setup (or Control Panel → Sound → Configure). Mac → Audio MIDI Setup → Configure Speakers.
- Connect through HDMI or optical to your receiver or soundbar.
- Use Chrome or Edge — they pass all channels to the system.
- Reload this page after changing the speaker setup.
Channel order
| Channel | Speaker |
|---|---|
| 1–2 | Front left and right |
| 3 | Center (dialogue) |
| 4 | Subwoofer (LFE) — only deep bass, so it sounds like a rumble |
| 5–6 | Surround left and right |
| 7–8 | Rear left and right (7.1 only) |
Frequently asked questions
It says only 2 channels are available
Your system is set to stereo. Change the speaker setup to 5.1 or 7.1, make sure your receiver supports it over the connection you use, and reload the page.
The subwoofer test is quiet
The LFE channel only carries bass below about 120 Hz. Check the receiver's subwoofer level and crossover settings, and that the sub is switched on.
Does this work with virtual surround headphones?
Virtual 7.1 headsets show up as 8 channels and mix them down to two ears, so you should hear each channel from a different direction.